SpecRacer.com • View topic - EVO4 Initial Set Up

Board index » Spec Racer Gen3

Change font size

Print view

EVO4 Initial Set Up

Post a reply

13 posts • Page 2 of 2 • 1, 2

Forum Hermit

Posts: 127
Joined: Thu May 30, 2013 6:36 am

Chassis: 577

Posted: Sat May 28, 2016 12:06 pm

My g dash has a stretch coil cable, so I don't expect problems good my to the left side pod. I also run a data hub because I use 2 smartycam hd gp, so you have a little more working space. Next week when I'm back I'll post some pictures of my gen 2 and 3 locations. The gen2 is a lot messier, as I have an expansion hub also for all the extra sensors. In the gen 3 I plan on just brake pressure, steer input, and oil t.

Scott Cypher
SRF3 #577 G3

Top

breton breton's Profile Needs a Life!!! Posts: 767 Joined: Wed Nov 30, 2011 12:21 am Chassis: 595	Posted: Sun May 29, 2016 1:06 pm Oil Temp is available from the ECU in the Gen3. Bob Breton - SRF 51 - San Francisco Region
Top

Still Learning to Type

Posts: 32
Joined: Mon Sep 30, 2013 8:54 pm

Posted: Tue May 31, 2016 3:15 pm

Lotus5 wrote:The cable supplied with the G dash seems kind of short. Not sure it would reach a location on the left side near the Gen3 ECU, for example. Is there some kind of extension cable? Or do you get one of the CAN extension hubs and use that?

Yes, you can get a CAN Extension cable for the G-Dash. 1, 2 and 4 meter lengths.

http://shop.veracitydata.com/products/c ... 5-pin-5pin

Top