Engine harness multi pin connector

Check out the latest version of the Spec Racer! LBoth ligher weight and more powerful!!! Available soon, racing in 2015!

Ready to Write a Book
Ready to Write a Book
Posts: 84
Joined: Mon Sep 09, 2013 10:03 am

Chassis:
469
PostPosted: Sat Dec 24, 2016 12:13 am
The engine harness has a nice multi pin connector. One half appears to be made to mount in a bulkhead. How have people handled this connector where it passes through the aluminum panel in front of the left rear tire? Mount the connector in that panel? Just leave the multi pin connector in the side pod and run the harness around the upper right corner of the panel? Anyone have photos?

Thanks for your help.
Scott Ross
#469

Needs a Life!!!
Needs a Life!!!
Posts: 260
Joined: Wed Feb 08, 2012 8:45 pm
Location: Daytona Beach, FL
PostPosted: Sat Dec 24, 2016 8:13 pm
On all of our cars the two meet just passed main frame 2inch center rail. Just under where the center section would bolt to its hole on frame mount. That is only as far as the engine harness will go. So the ECU harness has to go to that point to reach engine harness. Real close to clutch slave line to Transmission. Southeast Spec Racer, Tony

Return to Spec Racer Gen3

Who is online

Users browsing this forum: No registered users and 10 guests