Bracketology Gen3 Style
Posted: Tue Mar 14, 2017 4:08 pm
The current manual states that the upper right engine mount should have holes drilled between 1.625" and 1.75" above the top of the upper frame rail.
I'm not sure these are the dimensions I need. The distance I would like to know is how far above the braces at the bottom engine bay to the holes of the top bracket on the upper frame do I need that will insure I have the proper clearance for the shift linkage at the bottom of the engine
Then from there, how far above the lower braces should the holes be for the upper left transmission mount be to insure that the engine/transmission unit will be level in the engine bay?
If I place a piece of plywood in the engine bay on the braces then I can measure up to the brackets and locate the holes properly the first time.
This method would help eliminate differnces in the chassis over the years by suppling us with the critical dimensions to insure the proper clearances and a level engine.
Any thoughts?
I'm not sure these are the dimensions I need. The distance I would like to know is how far above the braces at the bottom engine bay to the holes of the top bracket on the upper frame do I need that will insure I have the proper clearance for the shift linkage at the bottom of the engine
Then from there, how far above the lower braces should the holes be for the upper left transmission mount be to insure that the engine/transmission unit will be level in the engine bay?
If I place a piece of plywood in the engine bay on the braces then I can measure up to the brackets and locate the holes properly the first time.
This method would help eliminate differnces in the chassis over the years by suppling us with the critical dimensions to insure the proper clearances and a level engine.
Any thoughts?