Page 1 of 1

TPS testing

PostPosted: Sat Apr 01, 2017 8:13 pm
by srcypher
I cannot seem to get the TPS to register in the ECU, neither quick nor auto. Is there a way to test with Ohm meter to verify? I can get variable ohms on the pins, but I don't know which ones the ECU references.

Thanks

Re: TPS testing

PostPosted: Fri Apr 21, 2017 8:19 pm
by Jparris
Scott:

I'll try to help, but what do you mean by 'register'? Are you trying to set the TPS in the ECU? If so, I assume you know there are two methods: one using the PE3 software and a manual method by just opening fully, shutting, then re-opening fully the throttle? Either method should work, but I'm unsure of where any values would be 'registered' in The ECU.

Re: TPS testing

PostPosted: Fri Apr 21, 2017 10:10 pm
by srcypher
Register = Ecu on computer shows a value when you twist the pot.

Figured it out with M. Davies; bad ground

Thanks, though