Page 1 of 1
TPS testing
Posted:
Sat Apr 01, 2017 8:13 pm
by srcypher
I cannot seem to get the TPS to register in the ECU, neither quick nor auto. Is there a way to test with Ohm meter to verify? I can get variable ohms on the pins, but I don't know which ones the ECU references.
Thanks
Re: TPS testing
Posted:
Fri Apr 21, 2017 8:19 pm
by Jparris
Scott:
I'll try to help, but what do you mean by 'register'? Are you trying to set the TPS in the ECU? If so, I assume you know there are two methods: one using the PE3 software and a manual method by just opening fully, shutting, then re-opening fully the throttle? Either method should work, but I'm unsure of where any values would be 'registered' in The ECU.
Re: TPS testing
Posted:
Fri Apr 21, 2017 10:10 pm
by srcypher
Register = Ecu on computer shows a value when you twist the pot.
Figured it out with M. Davies; bad ground
Thanks, though