Page 1 of 1

Wiring Diagram?

PostPosted: Sat Oct 14, 2017 8:10 pm
by Ed Cavalier
Is there a wiring diagram for the Gen3 online somewhere? If so, can someone point me to it?

Thanks,
Ed

Re: Wiring Diagram?

PostPosted: Sun Oct 15, 2017 3:47 pm
by Jisu Kim

Re: Wiring Diagram?

PostPosted: Mon Oct 16, 2017 4:03 pm
by Ed Cavalier
Jisu Kim wrote:I've been using this one.

http://www.accelracetek.com/schematics/


Thanks; I was hoping for one that included the fuel pump and its associated wiring.

Re: Wiring Diagram?

PostPosted: Wed Oct 18, 2017 6:13 pm
by Jparris
There is a list of the connections and pictures of the harness connectors for the power distribution harness in Appendix G of the GEN3 conversion manual. This may be of some help. The wiring directions for the in-cell fuel pump came with the pump conversion kit. If you don't have that, let me know and I can scan it and e-mail it to you. I'm sure you can also get it from Mike Davies or Nikki LaRue.

Re: Wiring Diagram?

PostPosted: Wed Oct 18, 2017 8:29 pm
by Ed Cavalier
Thanks! I'll talk to Enterprises.

Re: Wiring Diagram?

PostPosted: Sun Dec 10, 2017 1:40 pm
by brichardson
We just updated the website to include additional information on the GEN3 wiring. We now have connector pin-outs, schematics, and photos of the harness. Hope this helps. For the site go to www.accelracetek.com, go to the "Tech" pull down menu, and the select "Schematic".

Re: Wiring Diagram?

PostPosted: Sun Dec 10, 2017 2:27 pm
by Ed Cavalier
brichardson wrote:We just updated the website to include additional information on the GEN3 wiring. We now have connector pin-outs, schematics, and photos of the harness. Hope this helps. For the site go to http://www.accelracetek.com, go to the "Tech" pull down menu, and the select "Schematic".


Thanks! That will be a great resource. My fuel pump fuse was blowing. Sometimes virtually immediately, but sometimes at various, seemingly random, intervals. After tracing every possible wire, I guessed that it was either the pump itself or something internal to the main wiring harness. My CSR replaced the pump and all is well now. I want to cut-open the old pump to see if there's a "smoking gun", but I haven't got to it yet.

Ed