The options for rod ends always generates a lively discussion, here is a good starting point from the Pegasus web site: https://www.pegasusautoracing.com/document.asp?DocID=TECH00111&utm_source=201502-2&utm_medium=email&utm_campaign=201502-2
Pegasus Rod End Technical Page
6 posts
• Page 1 of 1
Needs a Life!!!
Posts: 1200
Joined: Wed Nov 30, 2011 1:38 am Location: Sunnyvale, CA Chassis: 068 415 Facebook Page: http://facebook.com/HSERacing |
Dave Harriman
"It looks crazy, I understand. But, we only live once and I am going to give it a good try." - Alex Zanardi |
Forum Hermit
Posts: 158
Joined: Tue Dec 06, 2011 12:26 pm |
But it should not, you purchase the best series rod ends from Aurora or else you are purchasing them again too soon.
|
When do you know a heim joint is due for replacement? If it moves freely and has no play, can I assume it's good?
|
|
Take stress (load) off the joint and inspect it for play between the rod end ball and its outer race (the inner part of the housing). If you detect any play here, it's time for replacement. |
|
Needs a Life!!!
Posts: 1200
Joined: Wed Nov 30, 2011 1:38 am Location: Sunnyvale, CA Chassis: 068 415 Facebook Page: http://facebook.com/HSERacing |
Or if it doesn't move at all. Dave Harriman
"It looks crazy, I understand. But, we only live once and I am going to give it a good try." - Alex Zanardi |
Needs a Life!!!
Posts: 308
Joined: Sun Dec 04, 2011 10:38 pm Location: Monument, CO Chassis: 540 |
You also need to look for bending or cracks in the threaded area. If the corner has taken a significant shot, like bouncing over a large curb (or off another car), a crack/bend can form where the threads enter the suspension part. This is particularly true on the lower control arm heim joint.
DaveP |
6 posts
• Page 1 of 1
Return to Technical and Repair Discussions
Who is online
Users browsing this forum: No registered users and 7 guests