Page 1 of 1
Rod Ends Sizes
Posted:
Wed Dec 02, 2015 1:33 amby Martinracing98
Hello
I am doing some winter work. Can anyone tell me what size the lower control arm rod ends are?
Re: Rod Ends Sizes
Posted:
Wed Dec 02, 2015 8:45 amby Dog Licked Racing
I only use Aurora rod ends for the LCA they are part number AU-PRM-10T.
But the answer to your question is .625 Bore, 5/8-18 Thread RH
Re: Rod Ends Sizes
Posted:
Wed Dec 02, 2015 4:23 pmby Bob Devol
Dog Licked Racing wrote:I only use Aurora rod ends for the LCA they are part number AU-PRM-10T.
But the answer to your question is .625 Bore, 5/8-18 Thread RH
For sure, use a brand name rod end like Aurora, Ampep, etc.
Re: Rod Ends Sizes
Posted:
Wed Dec 02, 2015 7:59 pmby Martinracing98
The lower control arm has two sizes. It has the big one out by the wheel and smaller ones at the frame. What size is the smaller one at the frame?
Re: Rod Ends Sizes
Posted:
Wed Dec 02, 2015 9:23 pmby KKloepfer
The inner is a RAM-7T or an AM-7T
Re: Rod Ends Sizes
Posted:
Thu Dec 03, 2015 1:03 amby Zealous
Perhaps it is the engineer in me but there is a difference in load rating between the RAM, AM and PRM series provided. The -7 or -10 specifies the size and T is for Teflon lined. But what is the reasoning for selecting one series (RA, A or PR) over the other? Cost? Shank or rod end failing before the upright? LCA failing before the rod end?
Re: Rod Ends Sizes
Posted:
Thu Dec 03, 2015 11:52 amby dave
Re: Rod Ends Sizes
Posted:
Thu Dec 03, 2015 10:14 pmby xvracer
Check out F.K. Bearing too. High quality and reasonably priced. [That is the FK Bearings in CT, not China]