Gen 3 ecu oil psi signal to dash

Technical and Repair Discussions
User avatar
Forum Hermit
Forum Hermit
Posts: 128
Joined: Fri Dec 30, 2011 6:29 pm
PostPosted: Mon Jun 18, 2018 3:14 pm
Hey group - I am resurrecting a CDS2 on my Gen 3 and have it all working but I am not clear on the oil psi signal from ECU. It appears that I need to select a sensor type to get a correct signal.

My guess because the answer looks reasonable is:

Sen-10C Typical

Anyone have notes to verify? General guidance appreciated.

I haven't tried plumbing in a guage but will to verify if I can't get a confirmation here.

TIA

JM

Return to Technical and Repair Discussions

Who is online

Users browsing this forum: No registered users and 3 guests


cron