Hey group - I am resurrecting a CDS2 on my Gen 3 and have it all working but I am not clear on the oil psi signal from ECU. It appears that I need to select a sensor type to get a correct signal.
My guess because the answer looks reasonable is:
Sen-10C Typical
Anyone have notes to verify? General guidance appreciated.
I haven't tried plumbing in a guage but will to verify if I can't get a confirmation here.
TIA
JM
Gen 3 ecu oil psi signal to dash
1 post
• Page 1 of 1
1 post
• Page 1 of 1
Return to Technical and Repair Discussions
Who is online
Users browsing this forum: No registered users and 13 guests