When manufacturing shafts with holes that see torque loads the holes should be reamed after drilling, on aircraft they are often honed after reaming. Any ridges left by a drill bit cause stress risers leading to the formation of cracks.
The process used to make our shafts probably has varied over the years.
Still not a very expensive but critical part worth considering replacing.
Main Steering Shaft Failure
11 posts
• Page 2 of 2 • 1, 2
![]() Forum Hermit ![]()
Posts: 158
Joined: Tue Dec 06, 2011 12:26 pm |
|
11 posts
• Page 2 of 2 • 1, 2
Return to Technical and Repair Discussions
Who is online
Users browsing this forum: No registered users and 35 guests