CAN connectors
14 posts
• Page 2 of 2 • 1, 2
Needs a Life!!!
Posts: 228
Joined: Wed Dec 28, 2011 6:21 pm Location: Stillwater, Mn Chassis: 784 |
So on my harness the round is labeled Data and the orange/yellow is labeled Dash yet the picture in the manual I see neither, but I see a 3rd one labeled data. I asked for the 4.3 Bosh interface for an Aim or CDS system. I guessing their both kind of the same, but haven't called Enterprise to ask the question yet. What do I have? Push the slider down to see the round.
|
Still Learning to Type
Posts: 32
Joined: Mon Sep 30, 2013 8:54 pm |
The upper connector is a Deutch DTM 6S (mating connector would be a DTM 6P).
The round connector is the Tyco Electronics (TE) connector with the CAN bus & power that I provided the pinout information. Thank you Peter Kelley for encouraging the necessary folks to do the right thing, and keep it common with another SCCA club racing setup. I would be interested in what the pinout of the "Dash" connector is, please post that if you find out. |
Needs a Life!!!
Posts: 228
Joined: Wed Dec 28, 2011 6:21 pm Location: Stillwater, Mn Chassis: 784 |
IDIOT ALERT. The orange/yellow is for the provided dash wiring harness. Believe it or not, I had it plugged in last week to check wire lengths but totally forgot about it!! I hope I can find my way back to the track in the next few weeks before I forget.
|
The round connector with 4 pins labeled "Data" has the 2 CAN pins in it. Enterprises sent me its mate and the pins for the mate on request, so I just pinned the AiM EVO4 ECU pigtail for the CAN +/- on the mating connector from enterprises.
Enterprises will send you the pinout on request, too. I'd post it but this site won't let me upload the pdf. Dash connector pins are: 1 Ignition 2 Tach signal 3 MAP switch DIG 6 In 4 Pit Speed Switch DIG 7 In 5 MIL Light DIG 9 Out 6 GND |
|
14 posts
• Page 2 of 2 • 1, 2
Who is online
Users browsing this forum: No registered users and 1 guest