I cannot seem to get the TPS to register in the ECU, neither quick nor auto. Is there a way to test with Ohm meter to verify? I can get variable ohms on the pins, but I don't know which ones the ECU references.
Thanks
TPS testing
3 posts
• Page 1 of 1
Scott Cypher
SRF3 #577 G3 |
|
Scott:
I'll try to help, but what do you mean by 'register'? Are you trying to set the TPS in the ECU? If so, I assume you know there are two methods: one using the PE3 software and a manual method by just opening fully, shutting, then re-opening fully the throttle? Either method should work, but I'm unsure of where any values would be 'registered' in The ECU. |
|
Register = Ecu on computer shows a value when you twist the pot.
Figured it out with M. Davies; bad ground Thanks, though Scott Cypher
SRF3 #577 G3 |
|
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests